The SDS F series includes the most successful cutting nozzles of
the AMT group. They impress with their high reliability and low
media consumption in daily use in steel works. The high nozzle
distance above the slab guarantees low wear and subsequently longer
life span.
In the autogenous cutting process, conventional cutting
technology reaches its limit with certain alloy compositions. This
is where the AMT Gega SDS FP nozzle series comes into play.
Combined with an AMT Gega powder system, this generation of nozzles
succeeds in significantly expanding the limits of what is possible
in alloy cutting. By adjusting the heating performance, an optimum
powder flow is achieved.
The SDS FB series is a special application for plate cutting
within the SDS family. Cut material thicknesses of 10 to 220
millimetres optimally with this distinct cutting nozzle. By
adjusting the pre-heating, edge melting on the cutting surface is
reduced.
The latest evolutionary stage in the AMT Gega nozzle series.
Patented with quick cutting processes in the concast section in
mind, for when the material is still hot. Significantly increased
cutting speeds allow shorter cut zones with reduced fuel gas
consumption and narrower cutting kerfs. Engineered to meet
increasingly stringent safety regulations in steel works, this
nozzle series guarantees a high model-related safety standard due
to its application of post mix technology.The shrouded design
offers the additional advantage of lower noise emissions and an
extended lifespan.
This unique high-pressure oxygen series was specially developed
for quick separation of the steel products from the strand and for
high productivity during secondary slitting and sub-dividing
operations. With regards to the crucial factor of cutting speed,
the patented AMT Gega HOT nozzle assumes a leading role in global
comparison, enabling siginificantly shortened work cycles.
This conically sealing thick cutting nozzle is constructed for
cutting thicknesses up to two metres. Due to its long, slim
geometry, media turbulence is reduced, enabling precise cutting of
high strength material.
The SD3 HSO has been optimised for manual operation. Allows for
uneven movements or changes to the nozzle distance during the
cutting process. The rugged construction also makes this nozzle
ideal for scrap cutting applications.
The HFD 1F series is especially designed for the hand scarfing
process. Well protected against abrasive movements with reinforced
wearing ring, allowing for a long lifespan. With its nozzle seat
well anchored in the nozzle holder, the HFD 1F introduces an
improved safety standard in the hand scarfing process.
Designed for the AMT Gega Scarfing Manipulator. The MBR 36
allows for a very fractional application, offering unrivalled
operational efficiency. It was being specifically designed for very
low gas consumption in scarfing processes. Within its duty cycle,
three separate assembly levels for scarfing are available.
Switching between scarfing levels controls the scarfing range on
the slab.